electronics bay造句
例句與造句
- Insulation blankets are used throughout modern airliners, including the electronics bay.
- The nose landing gear well and the main electronics bay also were damaged.
- When equipped for extended-range operations, the 757 features a backup hydraulic motor generator and an additional cooling fan in the aircraft's electronics bay.
- Because of heat generated at Mach 2 cruise, not only the crew compartment, but the wheel wells and electronics bay were pressurized and air conditioned.
- The part, located in the electronics bay under the cockpit, is called a DC tie bus, and is a component of the plane's 28-volt direct-current system.
- It's difficult to find electronics bay in a sentence. 用electronics bay造句挺難的
- Later investigation would determine that the two containers that could have contained M . Singh's bag were placed close to the sensitive electronic bay of the aircraft.
- EBay _ as in " electronic bay, " a tip of the hat to the company's Bay Area home _ quickly expanded its scope to embrace all manner of collectibles.
- They said they were interested in anything that could have ignited a fire in the electronics bay, which other evidence points to as a probable location of fire in the crash.
- One idea was for a transponder control panel in the cockpit with a panic button; when pushed, control is transferred to the electronics bay under the cockpit, which is difficult to reach in flight.
- After picking apart some of the wadded remains of the cockpit of Trans World Airlines Flight 800, investigators concluded Tuesday that the catastrophic explosion that destroyed the Boeing 747 most likely did not originate inside the cockpit or in the electronics bay beneath it.
- And if there is any thought to pulling up the hatch cover behind the captain's chair and looking down into the electronics bay beneath the cockpit, where investigators think the Swissair fire may have occurred, a three-person crew is much more likely to do that, he said.
- But I'll take your advice to measure the voltage up by the motor controller-I was indeed measuring at the terminals of the power supply just because it was easier to juggle two multimeter probes and a screwdriver in the cramped electronics bay while keeping all body parts well away from the 40, 000 volt laser power supply!